Your Cart

Heavy Duty Line Marking Paint

Heavy Duty Line Marking Paint
Heavy Duty Line Marking Paint
Heavy Duty Line Marking Paint
Heavy Duty Line Marking Paint
Viva Wallet
Viva Wallet
Secure Payments
Low Cost
Years of Knowledge
Heavy Duty Line Marking Paint

Available Options

dmd Epoxy  line marking is a fast curing two-pack, high build system for application of lines and hatching to floors at a thickness from 200 to 500 microns. The coloured high gloss finish is hard wearing and has good chemical resistance.


dmd Epoxy line marking can be applied to a wide variety of surfaces and finishes subject to appropriate preparation. It can be applied by brush roller or trowel to tapes and markers with the minimum of creep even on textured surfaces.



  • 2-component epoxy resin system
  • Consisting of epoxy resin and hardener
  • Water-based (solvent-free)
  • Thick high-performance coating
  • Colours: yellow, white
  • 1ltr


  • Very easy to use, no specialist knowledge required
  • Self-levelling after application with a paint roller or paint brush
  • Excellent adhesion on concrete, stone and certain asphalt floors
  • Can even be applied on already coated substrates
  • Only one coat needed
  • Minimum bleeding along the edges
  • No shrinking during curing
  • Glossy top coat
  • œExtremely durable and hard wearing
  • Suitable for forklifts and heavy goods vehicles traffic
  • Dust-free
  • Impenetrable
  • Odour-free
  • Easy to clean
  • Resistant to oils, fuels and lubricants, solvents and cleaning agents
  • Resistant to chemicals - dilute acids, bases, salt and sugar
  • Resistant to most bacteria
  • Application rate 1 l for approx. 50m length using line thickness of 50mm
  • Can be walked on after approximately 4-5 hours
  • Load resistant after 8-10 hours depending on temperature and humidity
  • Complete chemical curing time 5 days
  • Installation temperature from +10°C up to +30°C
  • Installation conditions - substrate must be dry, clean, free of dust and grease
  • Substrate preparation by sanding and priming recommended (see Accessories)
  • For open and porous substrates priming required, see Accessories
  • Fresh concrete must be completely cured
  • Processing time after mixing maximum 15 minutes


  • For heavy duty traffic in commercial and industrial units of all kinds
  • Warehouses with forklift traffic
  • Manufacturing facilities
  • Shops
  • Car repair shops
  • Vehicle halls and multi-story car parks
  • Showrooms and exhibition halls
  • Food industry
  • Dairies, breweries, bakeries, butcher shops and slaughterhouses
We use cookies to ensure that we give you the best experience on our website. Click here for more information or close to